9
o
If Host is on, press and hold POWER button for less than 2
seconds to start FOB search mode
POWER Button Light (Light Emitting Diode (LED))
o
Host OFF – LED OFF
o
Host ON, no registered FOBs – LED steady on
o
Host ON, at least one registered FOB – LED blinks
o
If the battery is good (>7V) the LED is green. Flash time 4s.
o
If the battery is low (>6V, <7V) the LED will be amber. 2s
o
If the battery is bad (<6) the LED will flash red. 1.5s
o
If the coil or the CAP is bad, the LED will be steady red.
RESET Button
o
Press the RESET button to silence AUTOTETHER
TM
alarm
o
If system is not in alarm mode, RESET button has no effect.
NOTE:
LED Flash times indicate cycle time. On time is always 0.5s
RESET Button LED
o
Host searching for FOBs – LED Flashing AMBER. 2 sec.
o
Alarm activated – LED Flashing RED. 1 sec.
o
In all other situations, this LED is off.
FOB Signal/FOB Battery Level LED’s on Host
o
One LED for each FOB (4 maximum)
o
Host ON and
FOB OFF or Unregistered – LED OFF
FOB Registered & OK – LED Flash Green during Host search
mode (1 second), then OFF
FOB Registered, batteries low – LED flashes AMBER (1
second) during Host search mode, then OFF
FOB registered, batteries bad – LED flashes RED (1 second)
during Host search mode, then OFF
FOB registered, signal interrupted – LED steady RED (alarm
mode)
If the host is not in search mode or alarm mode, the LEDs
are off
FOB Controls and Indicators
POWER Button
o
Press to turn FOB ON
