handleiding/manual
www.autostyle.nl
Attention:
The exist (if just lost 1 transmitter, one still in hand) learned the new transmitter code to let system still
keep memory the exist non-lost transmitter code again.
The system total can memory 3 pcs transmitter codes, and the 1
st
transmitter code will be instead by the 4
th
trans-
mitter, 2 instead by the 5
th
transmitter code.
If just 2 pcs transmitters to be learned, it is better to learn the 2e transmitter code 2 times to occupy the 3
rd
code
memory of control module to void the risk to be learned by unknown 3
th
transmitter codes.
Please refer the remote-table for how many times ignition off-on switching, then follow the above step1 to 3, and
example 1 for lock timing, passive lock, ignition lock/unlock features setting or delete.
* If passive arm and passive lock is set, the system will be auto armed and locked 30 seconds after turn off the
ignition, open and close door. The passive lock will not be enable if passive arm not set.
System was preset at passive arm disable/ 0.4 seconds lock timing/ passive lock disable/ ignition lock-unlock disa-
ble/ pin number: 24
System override & car-jacking release
A. Must be in armed state.
B. Open de door and let the door opened (will trigger the siren), the ignition also must be off.
C. Switch ignition to on, the LED will light on.
D. Switch ignition to off, LED will start to flash, then count the times of flash.
E. Switch ignition to on immediately after LED flash 2 times (same times as the TEN’s digital number).
F. The LED will be light on again when ignition is on.
G. Switch ignition to off, LED will start to flash again, then count the times of flash.
H. Switch ignition to on immediately after LED flash 4 times (same times as the Unit’s digital number).
I. If the TEN’s & unit’s digital number are correct, the system (or car-jacking) will be overrided to disarm state.
Please repeat from the step C to I to re-enter the correct PIN number if any error happened.
J. After the system is override, turn off the ignition & close the door.
Remote-Table
Be aware!!
If you want to perform a programming you must be certain that the black/white cable is
connected (must make mass) or else programming is not possible.
Ignition key OFF/ON
switching times
Feature setting
Car lamps will flash 1 time or 3 times to
confirm what feature or state is set after
press the button of transmitter
Flash 3 times
Flash 1 times
5x
Passive alarm
enable
disable
7x
Transmitter Code-learning:
Switching the ignition key off-on 7 times, and keep at on position at 7
th
time. The lamps will flash once after 3 seconds. Then press the transmit-
ter left (or large) button once. The lamps will flash 4 times to confirm the
transmitter code was learned. Please follow to learn the 2
nd
one.
8x
Ignition lock/unlock
enable
disable
10x
Siren or horn output
select
Siren output
12V output
Horn output
Pulse output
MANUAL Te 4402d ANd Te 4404d
