handleiding/manual
www.autostyle.nl
Usage
Left (large button)Arm/disarm
A.
Arm the system
Chirp once, lamp flash once, Led flash slowly.
Will start to sense the door open or ignition on 2 seconds after armed.
And will start to sense the sensor 30 second after armed.
Will chirp and flash 3 times if door is opened while arming.
B.
disarm the system
Chirp twice, lamps flash twice.
C.
Siren Stop
When alarm siren is triggering, may press this button to stop the siren sounding and system still keep in armed.
Right (small button) panic/car locating/trunk release
A.
Panic
When system is armed, press and hold this button approximately 2 seconds, it will let siren sound 30 seconds.
B.
Car locating
When system is armed, press this button once, it will chirp and flash 5 times.
C.
Trunk Release
When system is disarmed, press this button once, system will output a 1-2 seconds ’-‘’ signal for driving trunk
release relay.
Buttons pressed at same time: One time mute arm or disarm.
Attention:
Please to be sure the 2 buttons are press at same time for one time mute arm/disarm to void the
misfunction.
Ignition lock/unlock
This function is preset at ‘’disable’’, please refer the Remote Table for ignition lock/unlock setting.
Car Jacking protection
A. When ignition key is on, press & hold the left large button over 2 seconds, the lamps will flash twice.
B. After 40 seconds, siren will chirp 20 seconds.
C. After the above 20 seconds chirp, the siren will sound louder for another 60 seconds and at same time the
engine or starter (depend on you cut the ignition or starter) will be disable. After the above 60 seconds siren
sounding, system still keep armed the engine or starter still disabled, and siren will not be trigger any more.
System is dead.
Attention:
When ignition is on and presses the left large button over 2 seconds, the lamps flash twice, the
system will not accept any control by the transmitter, and only can enter the pin number to override the
system, disarm (release) the carjacking.
Remote setting
Passive arm/ transmitter code-learning/ passive lock/ ignition lock-unlock
A. Please disarm the system by transmitter.
B. Open the door and let door opened.
C. Please refer the remote-table for how many times ignition off-on switching for specific features setting or delete.
MANUAL Te 4402d ANd Te 4404d
Example 1: Passive arm setting or delete
A. switch on.
B. After 3 seconds, the lamp will flash once
C. Press the new transmitter left large button once
D. Please switch the ignition off-on 5 times, and keep
at on position at 5
th
time The lamps will flash 3
times to confirm is enable or flash once to confirm
the feature is disable
E. Switching off the ignition off to close the setting or
continuous another feature setting
Example 2: Transmitter code-learning
A. Please switch the ignition off-on 7 times, and keep
at on position at 7
th
time switch on.
B. After 3 seconds, the lamp will flash once
C. Press the new transmitter left large button once
D. The lamp will flash 4 times to confirm the code is
learned
E. Please switch off the ignition, then follow the above
procedure from step A to D learn the 2
nd
transmit-
ter code
Turn off the ignition and close the door may close the
code-learning
Read this before starting the installation!
AutoStyle is not responsible for consequential damages resulting from incorrect installation!
