Installation Guide
P. 7
Dome Light Delay
When the doors are being closed and the vehicle is armed, the module will check the dome light to detect
whether a door has been left open. If the dome light is on, the system will generate three chirps to warn the
user that a door has been left open (There is one chirp if Mode 1 – Function 5 – Option 2 is selected)
Retain Accessory Output
Retain Accessory output is activated as soon as key is turned to the ON position. When the key goes from ON
to OFF position, the accessory output stays ON and a countdown period of 10 minutes is set. The output is
turned OFF after 10 minutes or if a door is opened anytime during the countdown period.
Note:
The Accessory Output is also turned off while starting the car.
Zone 2 Disable Output
The unit is equipped with a zone-2 disable output that can be used to immobilize the vehicle when the system is
armed. Zone-2 disable operates in addition to the built-in starter kill.
The unit will give a negative output when the system is
armed
(locked by remote); this wire can therefore
control an external relay to interrupt the fuel pump or the Ignition.
The starter kill circuit can be configured to passive mode (to arm automatically) with a 1-minute timeout.
Otherwise it can be configured to active mode (in which it must be armed by the user).
Note
: Installation of a 2
nd
-zone disable requires an external relay
(not included!)
.
Multi-car Operation
This allows the user to control two systems with one transmitter. (Both vehicles must be equipped with identical
modules)
The remote transmitter of the primary vehicle can control the starter kill system, the door lock and unlock
operations of the second vehicle. The remote transmitter of the second vehicle can also operate the primary
vehicle.
*To program a transmitter for a second vehicle under multi-car operation, you must press on
button of the
transmitter in step 4 of transmitter programming procedure (see page 3).
Resetting the Module
The system is equipped with a reset function that allows the installer to erase all transmitter codes and return all
programming options to their factory defaults.
To reset the module:
1.
Flash the hood pin switch (see on page 4) - the parking lights will stay on for up to 20 seconds.
2.
Immediately press and release the valet button
5 times
.
3.
The parking lights will flash
8 times
upon reset.
Note
: After a reset has been performed, the system will set all options back to their default values
(see the
programming page for default values)
and all transmitters will need to be programmed again.
