P.4
http://www.autostart.ca
Quick Installation Guide
The Programming Button
(a.k.a. the P.B.)
The
P.B.
is located on the side of the module. This push button
mimics the hood-pin switch
in order to avoid
having to get out of the vehicle to press the hood-pin switch.
The P.B. will work only when the hood pin is
installed and the hood is up
(ground on the hood line).
Complete step by step module programming
1)
Entering Programming Mode
2)
Entering Programming Options
3)
Programming the options
4)
Adjusting the Horn output (if installed)
5)
Setting up the TACH, VTS or Multi-speed Tach
Warning!
Please note that the wire to wire brake communication is locked once an analog signal is detected on the
remote starter’s brake input. To detect D2D brake again, after being locked in “wire to wire” mode, make sure
no connection is made at the brake input wire, unplug the remote starter’s power and then plug it back in.
ENTERING PROGRAMMING OPTIONS
1.
In programming mode (page 3)
the parking lights will stay on for up to 20 seconds.
2.
Before the lights go out, press and hold the brake pedal and then press one of the following buttons.
LOCK
to access mode 1;
UNLOCK
to access mode 2;
TRUNK
to access mode 3;
START/STOP
to access mode 4.
3.
The parking lights
will flash 1, 2, 3 or 4 times to confirm entry into a mode.
4.
Release the brake pedal.
Once the desired mode has been selected, the unit will fall (by default) into function #1 of that mode; you can
now select the option you want in function 1. Once this option has been chosen, the unit will move on to
function 2 of the mode selected, and so on.
Entering programming mode using the
Hood Pin (or the P.B.)
Entering programming mode using the
A.P.B.
Press and hold the hood pin down for 4 seconds.
Make sure the hood is closed.
Release the hood pin.
The parking lights will turn
ON
for 1 second.
Turn the ignition key to the
IGNITION ON (RUN)
position.
While the parking lights are
ON
, press the hood pin
once more and release immediately.
The parking lights will come
ON
solid for
20 seconds.
You now have 20 sec. to select a submenu.
Within 5 seconds, press the programming button
on the antenna twice for 1 second each time.
The LED will come
ON
solid for 20 seconds.
You now have 20 sec. to select a submenu.
Note 1:
To exit programming mode, close the hood.
Note 1:
To exit programming mode, press on the
antenna button once (the LED will come
ON
) and
release.
Note 2:
For vehicles that require the ignition to be turned
ON
to activate the brake circuit, follow these steps to
select a submenu:
After flashing the hood pin, turn the ignition
ON
and wait for the parking lights to come
ON
(4 seconds).
Then, press the brake pedal to access the sub-menus.