Quick installation Guide
http://www.autostart.ca
P.3
TRANSMITTER PROGRAMMING PROCEDURE
Procedure
Confirmations
1.
Turn the key to IGN ON.
2.
Press, release then press and hold the antenna
programming button until the antenna LED
starts flashing rapidly.
The Parking lights will stay ON for 20 seconds. From
this point, the installer has 20 seconds to complete
steps 3-4.
3.
Pairing and programming the remote
Press and hold or
Side
button until the remote
generates a long beep.
Main remote (2-way remote):
PAIR MODE
text will
display on the remote LCD screen for a period of
30 seconds.
Companion remote (1-way remote):
The transmit
LED will start flashing every 2 seconds for a period of
30 seconds.
4.
Turn the key to OFF-ON-OFF.
The parking lights will turn OFF.
5.
Press Lock.
Main remote (2-way remote):
The remote LCD will
display
PASSED
accompanied by a melody. The
parking lights will flash 5 times to confirm successful
programming and pairing of the remote.
Companion remote (1-way remote):
The parking
lights flash 5 times and the remote will play a melody
to confirm successful programming and pairing of the
remote.
Proceed to
Step 6
to exit programming or repeat
Step 3
to continue programming other remotes.
6.
To exit programming, press and release the
antenna programming button.
The antenna LED will stop flashing rapidly.
Note:
To program the remote to a second vehicle that has the same system, in step 5, press the Trunk button
instead of Lock.
TRANSMITTER PROGRAMMING PROCEDURE USING PRG-1000
Important:
Make sure to use the new PRG-1000 T-harness (HAR-PRG664- sold separately).
Note that all remotes must be paired to the antenna (steps 1, 2, 3) before using the PRG-1000 to
program the remotes to the remote starter module.
Procedure
Confirmations
1.
Press, release then press and hold the antenna
programming button until the antenna LED
starts flashing rapidly.
2.
Pairing the remote
Press and hold or
Side
button until the
remote generates a long beep.
Main remote (2-way remote):
PAIR MODE
text will
display on the remote LCD screen for a period of
30 seconds.
3.
Press Lock.
Main remote (2-way remote):
The remote will play a
melody.
Once steps 1, 2, 3 are completed on all remotes, you must exit pairing mode (step 4) then use PRG-1000 to
program the remote to the remote starter. Follow the PRG-1000 screen for programming instructions.
4.
To exit pairing, press and release the antenna
programming button.
The antenna LED will stop flashing rapidly.
Note:
To program the remote to a second vehicle that has the same system, in step 3, press the Trunk
button instead of the Lock button.
ENTERING PROGRAMMING MODE
These are the programming buttons:
The Hood Pin
The Antenna Programming Button (the A.P.B.)