BEEPS DISABLED
1. Press and hold the TRUNK button UNTIL the transmit icon (Green) AND the siren icon
flash once each.
2. Let it goof the button and press it 4 more times within 5 seconds.
1 Beep = Beep Disabled
3 Beeps = Beep Reactivated
NOTE:
The 2 beeps confirming that the engine is running during the Status Request are not
disabled by this option.
VEHICLE STATUS REQUEST
The two-way transmitter has a built in feature that will allow the user to contact the vehicle
by remote and get a report of it’s current condition displayed on the information panel.
To request a status check, press and hold the LOCK & STOP buttons simultaneously.
Condition Icon
Flashes
Beeps
Engine OFF / Cold
Weather Timer OFF
None None
2
Engine ON / Cold
Weather Timer OFF
START 2 2
Engine OFF / Cold
Weather Timer ON
SIREN 2
2
Engine ON / Cold
Weather Timer ON
SIREN & START
2
2
Valet Mode
STOP & START
2
2
Armed/Locked LOCK 1 1
Disarmed/Unlocked UNLOCK
1
1
LOW BATTERY WARNING
The transmitter uses one 1.5-volt AAA battery that should be replaced when the Low
Battery warning occurs. If the battery voltage is getting weak, the remote will give a
warning when transmitting. All the icons on the display panel will flash 3 times to indicate
that the battery should be replaced.
E
E
X
X
T
T
E
E
N
N
D
D
I
I
N
N
G
G
R
R
E
E
M
M
O
O
T
T
E
E
B
B
A
A
T
T
T
T
E
E
R
R
Y
Y
L
L
I
I
F
F
E
E
To extend remote battery life, the system can be placed in battery saver mode by pressing
the STOP and UNLOCK buttons simultaneously for approximately 5 seconds. The
TRANSMIT icon on the display panel will become constant. To take the system out of
battery saver mode, press the STOP and UNLOCK buttons simultaneously until the
TRANSMIT icon is flashing.
NOTE: Placing the system in battery saver mode will disable the ability of your
remote to receive the confirmation of an alarm condition from your vehicle.
INTRODUCTION
The AS-4565TW is a state-of-the-art combination of an alarm and remote car starter
with command confirmation. It represents a breakthrough in vehicle convenience
technology, and remote starter systems.
USER SELECTABLE OPTIONS
The AS-4565TW was designed with flexibility and OEM integration in mind. The unit
can be customized and used in almost every possible application.
With the integration of Timed, Latched, or ON/OFF outputs, this unit can single-
handedly control virtually any electrical system in your car.
NOTE
: The programming of your system should be left to a professional. Changing
any of the settings may effect the operation of your AS-4565TW.
Please have your installer program the following options:
x
IGNITION CONTROLLED DOOR LOCKS
This feature will LOCK all doors once the brake pedal has been pressed for the
first time after starting the vehicle. When the key is turned to the OFF position,
the doors will be UNLOCKED.
x
REMOTE START RUN TIME
The AS-4565TW can be programmed by your installer to run the engine for 4, 15
or 25 minutes. The default run time is 15 minutes.
TRANSMITTER FUNCTIONS
Your AS-4565TW is equipped with a 5 button, 15-channel remote transmitter. It can
operate two independent Autostart equipped vehicles. (See Multi-Car Operation for 2
nd
car transmitter functions.)
The transmitter functions are as follows:
1
DISARM/
UNLOCK
ARM/LOCK
STOP
START
System Status
display Screen
TRUNK
8
