REMOTE STARTER VALET MODE
The system can be placed in Remote Starter Valet Mode. This disables the remote starting
capabilities while maintaining the alarm and door locking/unlocking functions. This is
recommended if the vehicle needs to be serviced.
To ENABLE the Starter Valet Mode, set the valet switch ON. The remote starter is now
disabled.
To DISABLE the Starter Valet Mode, set the valet switch OFF. The remote starter is now in
normal operation.
ALARM VALET MODE
The system can be placed in Alarm Valet Mode. This disables the alarm functions and the
starter kill feature, while maintaining the remote starting capabilities and door
locking/unlocking functions. You can also use the Alarm Valet Mode to stop an alarm
condition.
To ENABLE the Alarm Valet Mode, turn the ignition ON. Slowly set the valet switch from
OFF to ON. The LED will turn ON indicating that the Alarm Valet Mode is enabled. Then,
turn the ignition OFF.
To DISABLE the Alarm Valet Mode, turn the ignition ON. Slowly set the valet switch from
ON to OFF. The LED will turn OFF indicating that the Alarm Valet Mode is disabled.
Then, turn the ignition OFF.
MULTI-CAR OPERATION
This feature allows the owner of two AS-4565TW systems in two of their vehicles to
control both systems with one transmitter. To control the second vehicle’s system, press and
hold the TRUNK button and select the command button desired. (The TRUNK button acts
like the shift key on a computer).
LOCK
=
START
=
UNLOCK
=
STOP
=
ALARM FUNCTIONS
– To be programmed by your installer
Your system can be programmed in Passive or Active Arming Mode. In either mode, you
can arm or disarm your alarm system using your remote control (and lock or unlock your
doors at the same time, if installed).
NOTE:
When armed, your vehicle benefits from high security protection at all times,
whether the engine is running under the remote or not.
ACTIVE ARMING MODE
ARMING AND LOCKING DOORS
To arm the system and lock the doors in Active Arming Mode, press and hold the
LOCK button until the siren chirps once. The parking lights will flash once, and the
LED will flash slowly, confirming that the system is armed.
DISARMING AND UNLOCKING DOORS
To disarm the system and unlock the doors in Active Arming Mode, press and hold the
UNLOCK button until the siren chirps twice. The parking lights will flash twice and
the LED will turn off, confirming that the system is disarmed.
PASSIVE ARMING MODE
ARMING AND LOCKING DOORS
Passive Arming Mode works the same way as Active Arming Mode. However, the
system will automatically arm itself 35 seconds after the last door is closed.
NOTE:
The system will not arm automatically if a door is left open, or if you re-open
a door within the first minute.
DISARMING AND UNLOCKING
To disarm the system and unlock the doors, press and hold the UNLOCK button until
the siren chirps twice. Make sure you open the door within 35 seconds or the system
will automatically re-arm itself. Once inside the vehicle, you have 35 seconds to turn
the key to the ON position, or once again, the system will arm itself. If you want to
remain in the vehicle, leave your key switch in the ON position.
IMPORTANT NOTE:
If the system re-arms itself or if there’s an alarm condition,
simply press the UNLOCK button to disarm the system.
STARTER KILL
This feature (if installed) will immobilize the vehicle when the system is armed. A
relay physically interrupts the vehicle’s starter wire and prevents the hot-wiring of your
vehicle. The vehicle will not start with the key unless the starter kill has been disabled.
The starter kill is automatically enabled or disabled when the system is armed or
disarmed. If you place your unit in Valet Mode (See Valet Operation), the starter kill
will be disarmed.
3
6
