VPK104
4-Key Contact Closure Remote Pad Quick Start Guide
Hardware Review
Front View
1
Source Selection Buttons
2
Status LEDs
Rear View
1
LED In Port
2
Contact Out Port
Side View
Hardware Installation
Before you start, prepare 2 screws, 1 wall box, and some core wires.
1
(Optional) Prepare your installation site and install a Wall Box.
2
Remove the faceplate from the Remote Pad.
3
Ground the Remote Pad.
(a) Use core wires to serially connect the Remote Pad’s LED In (-) poles to the GND pole (
) of the LED Out terminal
on the Presentation Switch.
(b) Use core wires to serially connect the Remote Pad’s Contact Out (-) poles to the GND pole (
) of the Contact In
terminal on the Presentation Switch.
4
Use a core wire to connect the Remote Pad’s LED In Port 1 (+) to the LED Out pole 1 on the Presentation Switch. Repeat
this step for other LED In Ports.
5
Use a core wire to connect the Remote Pad’s Contact Out Port 1 (+) to the Contact In pole 1 on the Presentation Switch.
Repeat this step for other Contact Out Ports.
Package Contents
1 VPK104 4-Key Contact Closure Remote Pad
4 4-pole Terminal Blocks
1 User Instructions
1 2
48.5mm
69.4mm
2
1
37.3mm
3a
4
4
3
5
5
3b
