2
BASIC REMOTE OPERATIONS
This unit is a state-of-the-art combination of a vehicle alarm and remote starter system. Start by familiarizing yourself with the
alarm functions
of the unit that you need to operate first, before using the
remote starter functions
. This is especially
recommended if your unit is set in
Passive Arming Mode
that automatically controls the arming of your vehicle.
To start the car by remote, you must ensure that SYSTEM IS not in Starter Valet mode. Press the start button, for about 1
second
.
Once the button has been pressed the parking lights will come on to inform you that the unit has received your signal,
and has begun the start process. The car should be running after about 5 sec. The vehicles parking lights will stay on the entire
pre-programmed run cycle.
NOTE:
Do not continue to press the remote once the parking lights activate. Pressing the remote continuously for 4 seconds
will activate “Cold Weather Mode” and will not start the engine.
If the vehicle doesn’t start, the Autostart will shut off, wait a few seconds, and then re-try to start the engine again. The
Autostart will try to start the engine a total of 2, 3 or 4 times (programmable) before giving up.
With the vehicle running under remote control, press the Unlock button to DISARM and UNLOCK the doors then enter the
vehicle. Insert the key in the ignition and turn the key to the “ON” position.
Do not turn the key to the “START” position
with the engine running, this will cause the starter motor to reengage.
NOTE:
Do not forget to leave the heather or air conditioner turned on before leaving your vehicle. So that your vehicle can be
“PRE-WARMED” or “PRE-COOLED” by remote control.
MULTI-CAR OPERATION
The AS-4565 systems feature MULTI-CAR operation. This allows the owner of two Autostart systems in two of his/her
vehicles to control both systems with one transmitter. (Both vehicles must be equipped with an AS-4565.
The remote transmitter of the primary vehicle can control the starter disable system, the door locks and the remote car starter
and trunk operation of the second vehicle.
The remote transmitter of the second vehicle can also operate the primary vehicle
Second car control:
Pressing Trunk and Lock simultaneously controls Lock:
Unlock is controlled by pressing Trunk and Unlock simultaneously:
Pressing Trunk and Start simultaneously controls remote Start.
Pressing Trunk + Lock +Unlock simultaneously controls remote Trunk.
Pressing Trunk and Stop simultaneously controls remote Stop.
REMOTE DOOR LOCKS
If your system was installed with remote door locks, you will have the convenience of remote keyless entry.
To UNLOCK you doors, press and hold Unlock for about 1 sec. Once the doors have unlocked the parking lights will flash
twice to confirm that the doors are unlocked
. (Also disarming your starter kill.)
To LOCK your doors, press and hold LOCK for about 1sec. When the doors have locked, the parking lights will flash once.
(Arming the starter kill.)
ALARM FUNCTIONS
Your installer can program your alarm/remote starter in
Passive Arming Mode
, so that the system automatically arms itself
when you leave your vehicle, or in
Active Arming Mode,
so that you can arm or disarm your car at will.
In either mode, you can arm or disarm your alarm system using your remote control and if your system was installed with
remote door locks, you can lock or unlock your doors at the same time.
NOTE:
The alarm functions can be used and are active in the same way
whether the engine is running under the remote or
not
. In other words, your vehicle benefits from high security protection at all times.
