5
REMOTE STARTER VALET AND ALARM VALET MODES
The alarm/starter unit can be placed in
Remote Starter Valet Mode
to disable
the capability of starting the engine by the
unit
while maintaining the alarm and door locking/unlocking and trunk functions. This is recommended if the vehicle is to be
parked in a garage or if the vehicle needs to be serviced.
The alarm/starter unit can also be switched to
Alarm Valet Mode
to stop an alarm condition or to disable
the alarm functions
and the anti-theft starter kill feature. While in the Alarm Valet Mode, the remote starting capability, the panic mode and door
locking/unlocking and trunk functions are still operational.
NOTE:
Enabling Alarm Valet Mode is required if you want to
stop the initial alarm condition
that occurs when powering-
up the system.
Using one of the next options will permit the user to place the alarm/starter
in any one of the following combinations
using
the
single valet switch
:
•
Normal
operation
•
Alarm valet mode only
•
Starter valet mode only
•
Alarm and starter valet modes
*ENABLING ALARM VALET MODE
1. Make sure the ignition key is in the OFF position
2. Set the valet switch to OFF
3. Turn ignition ON and wait for two seconds.
4. Set the valet switch to ON. At this point the
LED turns and stays ON
to indicate that the Alarm Valet Mode is enabled
5. Turn Ignition OFF then turn Valet switch back to OFF.
DISABLING ALARM VALET MODE
1. Make sure the ignition key is in the OFF position
2. Set the alarm valet switch to ON
3. Turn ignition ON and wait for two seconds.
4. Set the alarm valet switch to OFF. At this point the
LED turns and stays OFF
to indicate that the Alarm Valet Mode is
disabled.
5.
Turn ignition OFF
ENABLING STARTER VALET MODE
1. Make sure you did set the alarm valet mode, as you require.
2. Set
the
valet switch ON
ON = No Starter
DISABLING STARTER VALET MODE
1. Make sure you did set the alarm valet mode, as you require
2. Set
the
valet switch OFF
OFF = Starter works
The remote starter is now in normal operation
