5
START button
for about a second until the parking lights come on to inform you that the unit has
recognized your remote. Once the lights come on, release the button on the remote. Your vehicle will now
start.
NOTE:
Do not continue to press the remote once the parking lights activate. Pressing the remote
Continuously for 4 seconds will activate the "Cold Weather" mode and will not start the engine.
If the car doesn't start, the unit will shut off, wait a few seconds, then try to start the engine again. The unit
will try to start the engine a total of two, three or four times (programmable) before giving up. When the
engine starts, the parking lights will stay on for the run time duration of 4, 15 or 25 minutes
programmable). If the engine stalls, the unit will try to start the engine again (maximum of 2, 3 or 4
attempts).
NOTE:
Make sure that you have the heater or air conditioner turned on before leaving your vehicle. The
unit will warm or cool your car when starting by remote control.
If the vehicle was armed,
remember to disarm
the system and unlock the doors with the
UNLOCK
button
, before entering the vehicle.
DRIVING-OFF
After having disarmed the system and unlocked the doors, enter the vehicle and do the following:
1. Turn the ignition key to the
ON position.
(
Do not turn it to the start position
, since the engine is
already running.)
2. Press the brakes to disengage the remote starter unit. You are now ready to drive off.
REMOTE TRUNK RELEASE
If your unit was installed with the trunk release option, you can open the trunk using your remote. This is
especially handy when you carry packages and need to open the trunk.
Press TRUNK button
until the parking lights flash once, then within 2 seconds
press the TRUNK button
again
until you see the parking lights flash again. You can also press and hold the
TRUNK button
continuously for 3 seconds
to accomplish the same task. The parking lights stay ON while you hold the
button.
REMOTE STARTER VALET AND ALARM VALET MODES
The alarm/starter unit can be placed in
Remote Starter Valet Mode
to disable
the capability of starting
the engine by the unit
while maintaining the alarm and door locking/unlocking and trunk functions. This
is recommended if the vehicle is to be parked in a garage or if the vehicle needs to be serviced.
The alarm/starter unit can also be switched to
Alarm Valet Mode
to stop an alarm condition or to disable
the alarm functions
and the anti-theft starter kill feature. While in the Alarm Valet Mode, the remote
starting capability, the panic mode and door locking/unlocking functions and trunk are still operational.
NOTE:
Enabling Alarm Valet Mode is required if you want to
stop the initial alarm condition
that
occurs when powering-up the system.
Using one of the next options will permit the user to place the alarm/starter
in any one of the following
combinations
using the
single valet switch
:
•
Normal operation
•
Alarm valet mode only (Kills Alarm
•
Starter valet mode only (Kills Starter)
•
Alarm and starter valet modes (Kills Alarm and Starter, trunk and unlock still work)
