2
BASIC REMOTE OPERATIONS
This unit is a state-of-the-art combination of a vehicle alarm and remote starter system. Start by
familiarizing yourself with the
alarm functions
of the unit that you need to operate first, before using the
remote starter functions
. This is especially recommended if your unit is set in
Passive Arming Mode,
which automatically controls the arming of your vehicle.
To start the car by remote, you must ensure that the system is NOT in VALET mode. Press the start button
(Thunderbolt), for about 1 second
.
Once the button has been pressed the parking light will come on to
inform you that the unit has received your signal, and has begun the start process. The car should be
running after about 5 sec. The vehicles parking lights will stay on the entire pre-programmed run cycle.
NOTE:
Do not continue to press the remote once the parking lights activate. Pressing the remote
continuously for 4 seconds will activate “Cold Weather Mode” and will not start the engine.
If the vehicle doesn’t start, the Autostart will shut off, wait a few seconds, and then re-try to start the engine
again. The Autostart will try to start the engine a total of 2,3 or 4 times (programmable) before giving up.
With the vehicle running under remote control, press the Unlock button to DISARM and UNLOCK the
doors then enter the vehicle. Insert the key in the ignition and turn the key to the “ON” position.
Do not
turn the key to the “START” position with the engine running, this will cause the starter motor to
reengage.
NOTE:
Do not forget to leave the heather or air conditioner turned on before leaving your vehicle. So that
your vehicle can be “PRE-WARMED” or “PRE-COOLED” by remote control.
MULTI-CAR OPERATION
The AS-4505 systems feature MULTI-CAR operation. This allows the owner of two Autostart systems in
two of his/her vehicles to control both systems with one transmitter. (Both vehicles must be equipped with
an AS-4505.
The remote transmitter of the primary vehicle can control the starter disable system, the door locks and the
remote car starter and trunk operation of the second vehicle. The remote transmitter of the second vehicle
can also operate the primary vehicle
Note
: The Stop button on this remote does not work.
Second car control:
Pressing Trunk and Lock simultaneously controls lock:
Unlock is controlled by pressing Trunk and Unlock simultaneously:
Pressing the Trunk and Start simultaneously: controls start/stop.
Pressing Trunk + Lock + Unlock simultaneously controls Trunk.
REMOTE DOOR LOCKS
If your system was installed with remote door locks, you will have the convenience of remote keyless
entry.
To UNLOCK you doors, press and hold UNLOCK button for about 1 sec. Once the doors have unlocked
the parking lights will flash twice to confirm that the doors are unlocked.
(Also disarming your starter
kill.)
To LOCK your doors, press LOCK button on your remote. When the doors have locked, the parking lights
will flash once.
(Arming the starter kill.)
