AS-1585 SH
Installation Guide
P. 13
Programming a Transmitter
Before you Proceed
The Transmitter of the Remote Car Starter is not delivered pre-programmed: it must be
programmed after the wiring of the Remote Car Starter is completed. The Remote Car
Starter has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
code-programmed, the code of the first Transmitter will be lost from memory.
To erase all
Transmitter codes from memory, you must perform a reset of the Remote Car Starter
(see
Resetting the Remote Car Starter
, later in this Guide, for more details).
The Transmitter Programming Procedure
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out, turn the Ignition Key to the
IGNITION ON (RUN)
position.
– Immediately turn the Ignition Key back to the
OFF
position.
2. Press and hold the
LOCK
button and keep it down until the
Parking Lights flash
5 times
quickly.
– The Remote Car Starter has stored the code of the Transmitter into memory.
3. To exit: close the Hood.
Table 2: Programming a Transmitter
To program a Transmitter
on the second vehicle for Multi-car Operation, you must press
the
TRUNK
and
LOCK
buttons simultaneously (instead of
LOCK
or
UNLOCK
) in step 3 of the
Transmitter code-learning procedure:
Entering Programming Options Mode
The Remote Car Starter is equipped with three custom programming Modes that allow the
installer to custom-fit the system outputs according to installation requirements. The
Programming Options are designed to facilitate interfacing with all vehicle types. (See
section
Table of Programming Options
later in this Guide.)
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out:
2. Press and hold the Brake Pedal,
– And press one of the following buttons on the Transmitter:
x
LOCK
..................to access Mode 1;
x
UNLOCK
..............to access Mode 2;
x
TRUNK
................to access Mode 3.
The
Parking Lights
will
flash
and the
Horn
will
honk
once, twice or three times to
confirm entry into a Mode.
3. Release the Brake Pedal.
Table 3: Accessing modes
