Autoquip American Lifts P-25-005, Руководство пользователя

Страница: 16 / 46

16
3. Verify installation area is clean before starting. Check mounting surface of pit floor with a level
or straight edge. If floor is not level, add shims or grout under entire perimeter of base to
achieve a level and flat base installation. A level base is essential for proper wheel tracking and
smooth lift operation.
Prevent serious injury or death.
Depending on model, weight of lift ranges from 220
– 2600 lbs.
Use a properly rated lifting device to move and install lift.
4. Lower lift into pit and check for proper height. Lift must be solid and flush with pit angle framing
(D). If needed, shim to
desired height. DO NOT “spot” shim. Shim along full length of frame.
This will prevent frame from sagging under load.
Prevent serious injury or death.
Electrical service installation must be performed by a licensed
electrician and conform to all local and national electrical codes.
NOTE : For larger horsepower motors, consult factory.
Motor Details Full Load Amps
HP HZ
P
H
RPM
TIME
RATIN
G
@115V
AC @208V
AC @230VA
C @460VA
C
½ 60 1 1725 30 MIN 8.4 - 4.2 -
¾ 60 1 1725 15 MIN 13.6 - 6.8 -
1 60 1 3450 5 MIN 12.8 - 6.4 -
½ 50/6
0 3 1425/172
5 30 MIN - - 1.8 0.9
¾ 50/6
0 3 1425/172
5 15 MIN - - 2.6 1.3
1 50/6
0 3 2850/345
0 30 MIN - - 3.0 1.6
1-
1
/
2
50/6
0 3 1425/172
5 30 MIN - - 4.6 2.3
5
I
D
60 3 3450 2 MIN - 15.8 14.8 -
5
I
D
60 3 3450 2 MIN - - - 7.4
5
H
D
60 3 3475 30 MIN - 16.0 15.2 -
i
WARNING
i WARNING