Page 1
SECTION 1 - FACTORY CONTACT INFORMATION
If you should need to call AquaCal AutoPilot, Inc. for questions, services, or parts, please have your
model and serial numbers available. Please also have the name of your installer and date of your
equipment’s installation. If you have questions, please refer to our web site for the latest manual
revisions, additional information, and helpful service advice.
Web
www.AutoPilot.com
Pool Volume
(Gallons/Liters)
Phone
(727) 823-5642
8-5 pm, Est., M-F
Installer
Install date
Fax
877-408-8142
Cell Model
Serial
#
Address
AquaCal AutoPilot, Inc.
2737 24
th
Street North
St. Petersburg, Florida 33713
USA
Digital Nano/Nano+
Model
Serial #
SECTION 2 - SAFETY INFORMATION
For personal safety, and to avoid damage to equipment, follow all safety instructions displayed on the
equipment and within this manual. Repair and service of your Digital Nano/Nano+ must be performed
by qualified service personnel. Should you suspect your chlorine generator is not performing properly,
refer to the section in this manual entitled: "Troubleshooting" on page 42 to determine if a call for
service is required. Warranties will be voided if the Digital Nano/Nano+ has been improperly installed.
Failure to properly operate, maintain or repair the Digital Nano/Nano+ will void the factory warranty.
Throughout this manual safety signals are placed where particular attention is required. Please note
"WARNING" signals relate to personal safety, while "CAUTION” signals promote avoiding damage to
equipment.
Follow all state provincial and NEC (National Electrical Codes) and applicable CEC (Canadian
Electrical Codes) unless local guidelines supersede. When installing and using your Digital
Nano/Nano+, basic safety precautions must always be followed, including the following:
WARNING:
Failure to heed the following may result in injury or death.
RISK OF ELECTRICAL SHOCK - Disconnect all AC power when installing or servicing
this system. Follow all state, local, and National Electrical Code(s) (provincial and
Canadian Electrical Code(s) if applicable). Use copper conductors only.
RISK OF ELECTRICAL SHOCK - Digital Nano/Nano+ contains no owner-repairable
components. Repairs must not be attempted by untrained and/or unqualified individuals.
If service is deemed necessary, contact installing dealer or AquaCal AutoPilot Customer
Support.
RISK OF ELECTRICAL SHOCK - A bonding lug has been provided on the outside of the
Digital Nano/Nano+. This lug permits the connection of a No. 8 AWG (8.4 mm
2
) solid
copper-bonding conductor (No. 6 AWG in Canada). Make this connection between the
Digital Nano/Nano+ and all other electrical equipment and exposed metal within 5-feet
(1.5 m) of the Digital Nano/Nano+. All field-installed metal components (such as rails,
ladders, drains, etc.) within 10-feet of the pool, spa, or hot tub, must be bonded to the
equipment grounding bus using copper conductors not smaller than No. 8 AWG
(8.4 mm
2
) (No. 6 AWG in Canada).
