28
4.
Press the
button first within 3 seconds, then press the
+
button on the transmitter together for 6 seconds, there will be a
confirmation six chirp with 3 long chirp and parking light flash 3 times
to confirming the system “Start Feature C & D Programming all returns
to factory default setting.
DATA BUS RESET FOR C I 3 INTERFACE
1. Turn the ignition ON then OFF 3 TIMES and stay in OFF position.
2.
Push the Valet switch
14
times (holding in on the
14
th
push
) until
six
chirps
with one long chirp is heard then release the valet switch. You are now in the
“Data Bus Reset Setting” programming mode.
Data Bus Reset:
3. Press and hold the
and
buttons at the same time on the transmitter,
there will be a confirmation
six chirps with three long chirps
to confirm the
system has reset the data bus.
SHUT DOWN DIAGNOSTICS:
The unit has the ability to report the cause of the last shutdown of the
remote start system.
Enter:
1. Turn the Ignition ‘switch to ‘ON position.
2. Press the
button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one
minute in the following grouped patterns:
LED
Flashes
Shutdown Mode
1
(-) Safety Shutdown input
(Hood)
1. Close the hood.
2. Check
H7/10
White/ Black wire
connection.
2
(+) Safety Shutdown input
(Brake) or
Neutral Safety Switch input
fail.
1. Check
H7/3
White/ Violet wire
connection.
2. Move the Enable Toggle Switch to
“ON” position. (If installed.)
3. Move the gear selector to “Park”/
“NEUTRAL” position.
4. Check
H7/4
Black/White wire
connection.
3
No RPM or
Low Voltage.
Tachometer Checking Type
:
Check
H7/9
White/Red wire connection
Voltage Checking Type
:
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
5
Over-rev
