Autopage C3-RS-625, Руководство по установке

Страница: 23 / 35

23
6 +
Vehicle
without Turbo
(The system
Can not Arm
with the
engine
running) Vehicle with
Turbo
(The system
Can be Armed
with the engine
running and
the engine will
run by itself
after the ignition
is turned off)
Press
and
buttons at the
same time to
control Engine
run time for
1
minute
Press
and
buttons at the
same time to
control Engine
run time for
3
minutes
Five chirps = Press and buttons at the
same time to control Engine run time for 5 minutes
Exit: Turn Ignition to ‘ON’ position, or leave it for 15 seconds.
3 long chirps & 3 parking light flashes will confirm exit.
START FEATURE “D” PROGRAMMING:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF
position.
2. Push the Valet switch
9 times (holding in on the 9TH push) until four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature
‘D’ programming mode.
3. Press and release the transmitter button corresponding to the feature
you want to program.
Press
Transmitter
Button One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse Three Chirps /
LED three
pulse Four Chirps /
LED four
pulse
1
Exit the programming mode.
(3 long chirp & 3 parking light flashes to confirm this exit.)
2 +
Tachometer
Check type (3A) Voltage check
type (go to 3B)
Timer
checking type
(go to 3B)
Data Bus
Interface
Mode**
3
A> RPM learning – see RPM Learning page 25.
B> Start Crank
Time:
0.6-second
0.8-second (2 chirps), 1.0-second (3 chirps),
1.2-second (4 chirps), 1.4-second (5 chirps),
1.6-second (6 chirps), 1.8-second (7 chirps),
2.0-second (8 chirps), 3.0-second (9 chirps),
4.0-second (10 chirps),
4
Low check level Hi check level
5
Start or Stop the system for TESTING & ADJUSTMENT