24
6
+
+ 50 RPM
DBI ONLY
No RPM learning
7
+
- 50 RPM
DBI ONLY
No RPM Learning
or < 50RPM
Exit:
Press the
button on the transmitter. 3 long chirps & 3 parking
light flashes will confirm exit.
** This will be used when connected to an Autopage CI3 compatible
Two-way data module that will recognize the tach signal from the
vehicle. This signal will need to be learned in the same manner as
the analog tachometer wire. If this learned value needs to be
adjusted, use steps 7 and 8 of this programming table
IMPORTANT NOTE:
You must program the “Tach Signal” before trying to remote
start.
RPM LEARNING / TACHOMETER CHECKING TYPE
TACHOMETER CHECKING TYPE:
Enter Start Feature ‘D’
Programming Mode:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
9
times (holding in on the 9th push) until
four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature
‘D’
programming mode.
Select “Checking Type”:
3. Press and release the transmitter
+
button once to set the
“Tachometer Checking Type”. [1] LED flash, [1] Horn chirp to confirm
this setting.
4. Once you complete step 3, you can program “RPM Learning Mode” as
follows:
