Equipment debugging
1. Connect the air source and power supply. Check whether the data of the air
pressure indicator is displayed normally and the power access is properly.
2. Make preparations for the debugging, including: Completely connect the
machine and the workbench; clean up the debris and dust on the workbench;
check whether the parts are loose, and clean up the objects that are randomly
placed on the machine or workbench.
3. First set to the blowing mode for trial operation from slow to fast debugging,
and then put the dry ice material into the machine for debugging if it is
determined that there is no abnormality.
Adjust the amount of dry ice blasting
1. Add the dry ice into the machine and cover it.
2. According to the degree of cleaning, turn the controller knob to adjust the dry
ice amount to achieve the best effect.
After the cleaning work
1. Turn the controller knob of the dry ice amount to the "0" position and turn on
the blasting gun for 30-50s until no water is blasted out.
2. Turn the knob controller to the cleaning mode, and the equipment will clean
the dry ice residue by itself. Manual cleaning is required if necessary.
3.Disconnect the power switch and air source, and put away the blasting gun
and accessories.
Common failures and troubleshooting methods
Common failures
1.The ice funnel in the dry ice container is blocked
2.The internal of the dry ice tube is blocked.
3.The dry ice tube leaks ice and air.
4.Poor cleaning effect, incomplete cleaning of relatively stubborn carbon
deposits
