18, Bansong-ro 513Beon-gil, Haeundae-gu, Busan, Republic of Korea, 48002
www.autonics.com | +82-51-519-3232 | [email protected]
-|Transparent Guide|-
Inner Lever Installation
1. Disassemble the handle fixing bolt using 4mm hexagon wrench.
Handle fixing bolt
2. Tighten the hexagon nut+spring inner lever with the designated tightening
torque using a spanner with 10mm width. If the inner lever is screwed loosely, it may
result in product failure.
Inner lever
Bolt
Tightening torque
Inner lever
9 to 10 N·m
• Keep cautious not to lose the hexagon nut and spring washer, when disassemble
the handle fixing bolt.
• Do not use handle when the handle fixing bolt is disassembled. It may result in
product failure.
• This inner lever is dedicated to Autonics SFDL-SDK. Do not use it for another
product or purpose.
Cautions during Installation
• Tighten the bolt with the designated tightening torque of each, using spring
washer/flat washer. Failure to follow Failure to follow this instruction may result in
product failure or damage.
Bolt
Tightening torque
Slide key unit mounting bolt (M6 BOLT) 6.0 to 7.0 N·m
Operation key mounting bolt
2.4 to 2.8 N·m
Switch mounting bolt
0.75 to 1.15 N·m
Above tightening torque is for the status of installing with spring washer/flat
washer.
• Apply additional methods such as glue to prevent loosening of the bolt. Mount the
slide base with all of 4 bolts.
• In order that the operation key is not to be tilted, mount the operation key tightly
onto the operation key mounting surface.
Operation key
mounting surface
• Install the between bolt slide and guide aligning them within ±0.5 mm from the
center line. Excessive wear and damage on the product may result in trouble in
operating the slide key unit.
±0.5 mm
±0.5 mm