Autonics LP-S070, Руководство пользователя, Страница: 7 / 175

Safety Precautions
© Copyright Reserved Autonics Co., Ltd. vii

When switching the mode to RUN mode, make sure that supply power to LP, I/O unit and
load first. If not, output error or miss-operation may cause.
It may cause a fire, human injury or property loss.

Do not use the product in an area or an environment not specified in the manual.
It may cause a fire, human injury or property loss.

Do not connect, inspect or repair when power is on.
It may cause a fire or give an electric shock.

Do not disassemble the product. Please contact us if it is required.
It may cause a fire or give an electric shock.

Please use the rectified power with insulation trans.
It may cause a fire or give an electric shock.

Do not use the power to the exceeded rated voltage.
It may cause a fire or give an electric shock.

This product uses lithium battery, do not disassemble or burn up.
It may cause an explosion or a fire.

Wire properly after checking power terminal polarity.
It may cause a fire or a malfunction.

Please read all notes and cautions related to installation and wiring in the manual.
If this is not observed, electrical shock or malfunction may occur.

Make sure the ground wire of Logic Panel is wired separately from the ground wires of other
devices. Ground resistance must be less than 100
Ω
, and a lead wire of which sectional
area is over 1.25mm
2
should be used.
If this is not observed, electrical shock or malfunction may occur.

When connecting Logic Panel ports and constructing input/output, check the pin number
and terminal block before connecting.
It may cause a fire or a malfunction.

Please tighten bolt on terminal block with specified tightening torque.
It may cause a short circuit, fire or a malfunction.

Do not press the surface of the touch panel with sharp or hard objects.
The touch panel may be damaged.

Keep Logic Panel at the specified temperature.
If stored at a temperature beyond the specification, damage may occur.

Do not inflow dust or wire dregs into the unit.
It may cause a fire or a malfunction.

Do not use in an area with excessive humidity or temperature.
The Logic Panel may malfunction, or its useful life may be shortened.

Do not close ventilating opening of this product.
Malfunction may occur due to temperature increase.

Keep the product out of direct sunlight or excessive dust.
The Logic Panel may malfunction, or its useful life may be shortened.