Automationdirect.com Stellar SR44, Руководство пользователя

Страница: 210 / 238

Appendix A: Setup Examples
A.1.12 – Setting the Low Amps Level and
Using the K2 Relay to Display the Status of Low Current Bit (continued)
(continued from previous page)
18. With ‘Map From’ on the top line of the display, press the
쑼
button.
19. Press the ENTER button to select ‘Bit Number’.
20. Press the ‘Optimise’ button to move the cursor to bit 3.
21. Press the
쑿
button to change the bit state to one (1). (This may not be necessary; bit 3 may
already be a one).
22. Press the Enter button to confirm any changes, the display will flash.
23. Press the # button four times to return to Stopped and ready.
Only one bit in any relay bit mask may be set to a positive bit state (set to one (1)), at any one time. To
turn off any other bits, simply use the ‘Optimise’ button to navigate to the required bit, and press the
쑼
button to change its bit state to zero (0).
To keep the above settings, they must be permanently saved. See section A.1.5
20 21 21
21
22
#
23
(continued from previous page)
18
19
Optimise Optimise
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019
A–16