O
pe
ra
to
r
P
an
el
O
pe
ra
to
r
P
an
el
4--3
Configuring Your Operator Panel
To prepare your application, use the
Application Worksheets which are
provided in Appendix A of this manual.
The example worksheets will help you
configure the OP--440 panel. The blank
worksheets can be photocopied and
used in planning your own applications.
OptiMate
OP-WINEDIT
3
IBM type 386 or above
3
Windows 3.1 or later,
including Windows 95, 98 or NT
3
1 meg of hard drive
3
1 meg of RAM
Your personal computer must meet the following
minimum requirements:
How to Configure Your Panel
Follow these steps to configure your OP--440 operator panel.
Load OP--WINEDIT
-- If you are not already using the configuration software or have
an older version, you must install version 2.3 or later (if you are using an older version
of OP--WINEDIT you can obtain an upgrade at our web site). The software is
provided on one 3-1/2 inch high-density diskette and comes with its own manual. Here
are brief installation instructions.
S
Place the installation disk into your computer’s floppy drive (usually
either drive A or drive B).
S
Open Microsoft
t
Windows (3.1 or above). For Microsoft Windows 95 or
NT the
Start/Run
program task bar is located at the bottom left portion
of your screen. For Microsoft Windows 3.x versions select
File/Run
from the Program Manager screen.
S
Select
Run
, and a pop-up window appears. Type in the path for the
drive in which you have placed the setup disk and designate the file
setup
. Click on
OK
when you are finished.
Connect Panel to PC
-- Connect the OP--440 to your personal computer using the
OP--CCBL configuration cable. Make sure the OP--PS400 5VDC power supply is
connected.
Application
Worksheets
Computer System
Requirements
Step 1
Step 2
StockCheck.com
