Automationdirect.com H0-ECOM, Руководство пользователя

Страница: 39 / 129

Ethernet Communications Modules, 3rd Edition, Rev. D
3–6
Chapter 3: Configuring ECOMs Using NetEdit3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Ethernet Address
The upper left section of the NetEdit3 screen displays
the Ethernet Address of the modules currently on the
network.
If modules are added or removed from the network,
click on the Scan Network button to update the
list. Notice that the MAC Address is the factory-
assigned address that is on the permanent label on the
module.
Select a specific module here by clicking on the MAC
Address or by using the arrow keys. The selected
module is highlighted.
NOTE: The Module window may list the MAC Addresses of devices not covered by this manual.
Module Type, IP Address and ID
The upper mid section of the NetEdit3 screen displays the Module Type, IP Address, module
ID, Name and Description of the modules currently on the network.
A new ECOM will have an IP Address of 0.0.0.0, a Module ID of 0 (zero), and no Module
Name or Description. To assign or change a module an IP address, ID, name or description
refer to the EBC Settings>General Information description later in this section.
Right clicking on an ECOM module listed on the
NetEdit3 screen will display the window to the right.
This is an alternative to using the Module Info or
ECOM settings tabs (shown below) to access the
module’s configuration settings. The settings are
discussed later in this section.
General...
Advanced...
RX/WX Node Map...
Test CPU Access!
Update Firmware...
Update Booter...
Restore Factory Settings...