SETTING LIMITS
17
STEP 16
SETTING TRAVEL LIMIT POSITIONS
METHOD TWO: VIA THE TRANSMITTER
IMPORTANT NOTE:
The OPERATE button will not
function until the open and close limits positions are set.
Remove the controls cover to access the controls panel
as shown in fig 26 page 16
16.1
CODING TRANSMITTER FOR SETTING LIMITS
1.
Press and hold the Door Code button (Fig. 29).
2.
Press button 1 on the transmitter for two seconds.
Release and pause for two seconds. Press the same
button again on the transmitter for two seconds.
3.
Release Door Code button.
16.3 SETTING LIMITS
NOTE:
The door and shuttle must be engaged into the
chain index and the door should be open approximately
half way.
1.
Press button 4 (Fig. 31), the door will start closing,
release the button once you are 1 to 2 cm from your
desired closed limit position.
2.
inch the door to your desired closed position by
. Pressing button 4
3.
Once you are happy with the position press button 2,
this action will store into memory the closed limit
position.
4.
Press button 1, the door will start opening. Release
the button once you are 1 to 2 cm from your desired
open limit position.inch the door to your desired
open position by. Pressing button 1
IMPORTANT WARNING:
Please be aware that the
garage door will start closing automatically once step 5
is performed. The door will also automatically re-open
after fully closing with a small pause between the cycles.
5.
Once you are happy with the position press button 2,
this action will store into memory the door limit
position. The door will now automatically close to its
limit position then fully open to calculate the safety
obstruction forces (ISS).
Please be aware of the above warning.
FIG. 30
FIG. 31
INCH OPEN
BUTTON 1
INCH CLOSE
BUTTON 4
SET
BUTTON 2
15.2 RESETTING DOOR LIMIT POSITIONS
The door travel limit positions can be deleted for new
positions by the following steps below:
1.
Press and hold the (-) button (Fig. 30) for six (6)
seconds until you hear three beeps and the red
Close Limit LED starts to flash. Release the button.
2.
Follow STEPS 15.1 to set new travel limit
positions.
FIG. 29
