24
GDO-10V3L2 Toro
™
Owner Installation Instructions
Parameter
Min
Max
Default
Step
Unit
Menu No.
Section
EVENT COUNTER
8.6
Appendix D
INSTALL DATA
8.7
Appendix D
PARAMETERS
8.8
Appendix D
VERSION INFO - Firmware
8.9
Appendix D
Menu 9 - Memory Tools
CLR CONTROL
9.1
Appendix E
CLR TRANSMITTERS (TX’ERS)
9.2
Appendix E
Menu 10 - Setup Travel
SETUP LIMITS
10.1
11.1
REPROFILE TRAVEL
10.2
12.5
SET PEDESTRIAN
10.3
15.1
A - Console Menu Structure
Appendix
This section illustrates how to locate, view and adjust
parameters in the logic console unit.
Locating parameters
Refer to MENU STRUCTURE on Page 15 or the preceding
section for CONTROL BOARD ADJUSTMENTS. Locate
the required parameter and note the MENU number. The
example used in
(Fig. B.1)
displays Menu 2.2 “100% O/L
Time”
Changing Settings
a. Press NEXT/PREV to navigate to the required menu.
b. Press SET to show the sub-menu.
c. Press NEXT/PREV to go to the required sub-menu.
d. Press OPEN/CLOSE to change the parameter setting.
e. Holding the button down causes the parameter’s value
to change rapidly.
f. The longer the button is held, the faster the value
changes.
g. Press SET to SAVE the setting.
Reload Default Setting
a. Press NEXT/PREV buttons to display the LOAD
DEFAULT screen.
b. Press SET to load the default value.
Return To Menu
If the parameter’s value is not to be changed, press STOP
to return to the sub menu. Press STOP again to return to
the MAIN SCREEN.
2: 100% O/L Time
(sec) 10
(sec) 1
∆
2: 100% O/L Time
Parameter
name
Parameter
value
Displays
next
parameter
in list
Parameter number
in sub menu
Displays
previous
parameter
in list
Returns back
to menu
Enter Edit Mode
View Mode (No cursor)
Edit Mode (Cursor shown)
Increase
value
Displays “Load
Default?” screen,
giving option of
loading default
value
Exits back to View
Mode
Decrease value
Saves new
value
Fig B.1
Fig B.2
Appendix
B - Viewing & Editing Logic Console Parameters
