Automatic Products SNACKSHOP LCM3 Series, Инструкция по эксплуатации

Страница: 9 / 81

components
5
installation
front and rear. (Figure 4.) Continue loading all spira l s. A d j u s t
with spacers where needed in the top shelf. R e t u rn the top
shelf to the vend position and fo l l owing this procedure, load
the remainder of the large spiral shelve s. The shelf divider
s e p a rating the right (lock side) column from the next column
is mova ble to allow vending of products wider than 5-1/2'' in
the second column. If this is used, the right column must be
used to vend narrower products.
6. Loading Main Product Candy Shelves. The 10-selection
(candy type) shelves are loaded similar to the 5-selection
shelves, except that, the bottom of the product sits on the
shelf in front of the spiral wire (Figure 5.) that rests on the
shelf. These products must also fit properly in the spiral
space.
Do not force product into spiral. These spirals are
removed and installed the same as the large spiral (Figure
3.), except that, the front end position is different (approxi-
mately 5 o’clock) (Figure 5.) and the front left side of the spi-
ral must be behind the small tab located on the left side of
the product space side wall. (Figure 5., Detail A)
7.
Product Spacers, 10-selection shelf.
The 10-selection
shelves are equipped with a product spacer (Figure 6.) that
can be pivoted from the right side of each product space.
These spacers should be pivoted out to hold the product
upright, but not tight against the product. Leave about 1/8''
clearance between the spacer and the product.
8. Product Pusher. The machine contains enough pushers for
you to install a pusher on each candy spiral.This plastic part
is designed to push the top of the product forward while it is
vending, helping it to fall from the shelf. It can also be used
with products that have the wrapper end flap on the outside
of the package. In this case, the pusher prevents these prod-
ucts from hanging on the spiral by spreading the flap. The
pusher is installed approximately 210 degrees from the front
end of the spiral with the tab extending forward. (Figure 7.)
Locate the pusher in its proper position, hold it against the
spiral wire and push the semi-circular part around the spiral
wire.
9. Bagged or Boxed Items in the 10-selection shelves, if not
loaded properly, could be a problem. The sealed edge of
the bag may get under the spiral wire causing the product
to hang up after it has been vended. It is recommended
that the lower edge of these types of product be folded for-
ward and up (Figure 8.) next to the product before insert-
ing into the spiral space. It is also recommended to use an
18 count spiral for bagged items because of the product
settling to the bottom of the package.
10.
Cigarette Vending from Snackshop LCM4.
Cigarettes
can be vended from the candy shelves using the 15 capac-
ity spiral for the soft pack regular, king, 100mm or 120mm
packs. The 12 capacity spiral should be used for box packs.
11. Lock Product Shelves. After all the product has been
loaded, be sure all shelves are returned to their vend posi-
tion behind the front roller guide.
12.
Install Proper Price Tabs
into price tab holder for each
selection in the main product area. (Figure 9.)
13. Loading Cans. The machine is set for 12 oz. cans only.
There are 10 can selections total in the machine. The top 5
Figure 5. Placement of product on main product candy
shelves and front end position of spiral.
Figure 4. Alignment of moveable product spacers.