Automatic Products SNACKSHOP LCM3 Series, Инструкция по эксплуатации

Страница: 15 / 81

11
cleaning
The Snackshop LCM will do the best merchandising job for you
if it is kept clean.The display window can be cleaned with any
good glass cleaner. The exterior and interior surfaces should
be cleaned with warm water and mild detergent. Rinse thor-
oughly and dry all surfaces.
The main product shelves can be best cleaned with the spirals
and product spacers removed. Refer to page 4. for removal of
spirals and page 5. for removal of the product spacer.
Clean the acceptor on the changer frequently, accumulated
dirt in this area can cause coins to hang or not be accepted.
Follow recommended cleaning procedures as described by the
manufacturer.
1. Ventilating Fan: (Part #660441 - 120 volts)
(
Part #660441 - 230 Volts
)
The ventilating fan keeps a steady flow of air moving through
the vendor cabinet. Installation of the fan takes only a few
minutes. All the vendors are wired with a fan plug on the
junction box for easy installation.
2. Special Spirals. Special candy spirals are available for use
in the 5-selection snack shelves. For the sake of identifica-
tion, the back end of these spirals are colored RED and
should never be used in the 10-selection candy shelves.
These spirals allow vending products that are too wide for
the standard candy columns, but, may be too thin for the
regular snack spirals. A product pusher and spacer should
be used where required. Part numbers for these special spi-
rals are as follows:
400139-1 12 space special spirals
400140-1 15 space special spirals
400141-1 18 space special spirals
400142-1 24 space special spirals
400143-1 30 space special spirals
400151-1 20 space special spirals
3. Soup Dispenser LCM (Kit 750083)
A canned soup dispenser is available as an option for use in
the 5-selection snack shelves. The dispenser is easy to
install and holds up to nine cans in the unit.
4. Dollar Bill Va l i d a t o rs & Change rs . The validators &
changers take only a few minutes to install and may be
purchased through the manu facturer of the unit. L C M
machines will only use 24 volt validators & changers.
Coin Mechs
24 Volt models - 15 pin plug only
Mars TRC-6010XV
VN-4010
Coinco 9302LF
Conlux USLX-004-01F
Multi Drop Bus (MDB)
Mars TRC-6510
VN-4510
Coinco 9302GX
Conlux USLZ-004-01F
Bill Validators
24 Volt models - Micromech
Mars VFM1-L2-U4C
VFM3-L2-U4C
VN-2502-U5E
Coinco BA32SA
BA32R
Multi Drop Bus (MDB)
Mars VN-2502-U5M
Coinco BA32SA
BA32R
5.
Can Storage Tray
(Kit 750184) LCM 4
The storage tray is used to store spare cans inside the
machine.
CAUTION:
Do not use any cleaners containing silicon, as this
could cause electrical failures.
IMPORTANT:
Can Vendor: clean the refrigeration screen (Page 57,
Item 6.) weekly to prevent voiding the warranty on the
refrigeration unit.
NOTE: The difference between the standard candy
spiral and the special candy spiral used in the wide
snack columns is in the overall length of the spiral.
The special spiral is shorter than the standard
candy spirals.
CAUTION:
Do not attempt to use the special candy spirals in a
10 selection shelf.
optional equipment