SE6166 Controller • Rev. 4/13/2011
11
© 2011 Automated Logic Corporation
Color Code
Black, white, green, red
Shielding
If shielded, Aluminum/Mylar shield (100% coverage) with TC
drain wire
UL temperature rating 32–167°F (0–75°C)
Voltage
300 Vac, power limited
Listing
UL: NEC CL2P, or better
1
Turn
off
the SE6166's power.
2
Partially cut, then bend and pull off the outer jacket of the Rnet cable(s). Do not nick
the inner insulation.
3
Inner insulation
Outer jacket
Foil shield
.25 in.
(.6 cm)
4
Strip about .25 inch (.6 cm) of the inner insulation from each wire.
5
Wire each terminal on the SE6166's
Rnet
port to the terminal of the same name on
the RS room sensor.
NOTE
If using shielded wire, connect the shield wire and the ground wire to the
Gnd
terminal.
6
Set the
Stat Select
jumper to
Rnet.
7
Turn
on
the SE6166's power.
Use 22 AWG, unshielded wire, maximum length 100 feet (30 meters).
1
Turn
off
the SE6166's power.
2
Wire each terminal on the SE6166's
LStat
port to the terminal of the same name on
the LogiStat.
3
Set the
Stat Select
jumper to
LogiStat.
4
Turn
on
the SE6166's power.
To wire an RS
sensor
LogiStat wiring
specifications
To wire a LogiStat
sensor
