RAM™ 16-F & 16-Fp Space Saver Frozen Fry Dispensers
Copyright © 2019 Automated Equipment LLC All rights reserved. Published 8/19
5
Dispenser Assembly
Note: Before assembling the Dispenser it is recommended that all parts be cleaned, sanitized,
dry, and handled in a sanitary manner. Refer to the Cleaning Procedures for more information.
Install the Drip Tray under the cabinet outlet, lifting it slightly over the cabinet supports. Position the
Drip Tray Spacer on the Drip Tray in the mounting slots.
With the dispenser turned off, align the Outlet Door with the Door Alignment Arrow and slide the Outlet
Door over the shaft toward the back wall engaging the Alignment Arrow. (See page 10 if the alignment
Arrow is in the closed position.) With your hands removed, turn the dispenser on, the Outlet Door will
retract into the closed position.
Install the Drum into the Hopper making sure the square opening in the drum is pointed toward the rear
of the Hopper. Install the Fry Diverter in the Hopper by sliding the Fry Diverter tabs into the slots
located on the inside Hopper wall. Install the hopper assembly into the cabinet by sliding them onto the
hopper supports. DO NOT force the drum on to the shaft. Rotate the drum in the hopper until the
square opening meshes with the drum motor shaft, then slide the hopper assembly backward until it
drops into place.
Drum
Fry Diverter Hopper Assembly
Drip Tray
Outlet Door
Door Alignment Arrow
Drip Tray Spacer
