Assembly
4.Swing the screws (F) 90
°
and pull off
upwards.
5.Check the feed roller (G). The appropriate wire
thickness must be specified on the top of the
feed roller (G). The feed roller (G) is fitted with
two guide grooves. Turn the feed roller (G) over
if necessary or replace it.
5.Position the feed roller holder (G) again and
secure it.
6.Remove the gas nozzle (10) from the torch (11)
by turning it clockwise, unscrew the contact tube
(15). Place the hose package (9) on the floor as
straight as possible pointing away from the
welding set. (See page 8)
7.Cut off the first 10 cm of the welding wire to
produce a straight cut with no shoulders,
warping or dirt. Deburr the end of the welding
wire.
8.Push the welding wire through the guide tube
(C) between the pressure and feed rollers (G)
into the hose package mounting (H).
Carefully push the welding wire by hand into the
hose package until it projects out of the hose
package by approx. 1 cm at the torch (11).
9. Push the pressure roller holder(E) upwards and
Pull the pressure roller spring(D) and swing it
downward.
10.
Screw the appropriate contact tube (15) for
the welding wire diameter on to the torch (Fig. 11)
and fit the gas nozzle(10), turning it clockwise.
11.Set the adjusting screw for the roller brake (I)
so that the wire can still be moved and the roller
stops automatically after the wire guide has been
braked.
F
G
C
H
I
E
D
MIG100/MIG130 10