autogaz AC STAG-200, Руководство пользователя

Страница: 22 / 34

Strona 22 z 34
ƒ
Increase the number of displayed points (only for loaded graphs)
When the controller works with LPG, a continuous line appears at the top of the oscilloscope; its
colour corresponding to the LPG ignition time.
2.11. Errors
The Error window shows the following field:
ƒ
Continuous acoustic signal for errors – if selected, acoustic signals will inform of an error until
manually turned off by the user. If unselected, the acoustic signals will remain on only for a
set amount of time.
The Actual Errors window shows current errors recorded by the controller and the Saved Errors
window shows errors recorded during the controller’s operation.
The following errors may appear during operation:
ƒ
Injector No. […] Error – no LPG injector No. […] or injector damage
ƒ
Voltage Error – voltage at the controller’s power supply lower than 9 [V]
ƒ
LPG pressure too high – the LPG pressure has been two times higher than operational
pressure for 60 seconds (a reducer problem)
ƒ
LPG pressure too low – the LPG pressure has dropped under the min. pressure value for a set
amount of time.
ƒ
No petrol injection – the controller has detected a lack of petrol injector signal for one or
more petrol injectors.
ƒ
Data error, check settings! – the controller has detected a settings error, check all controller
settings.
ƒ
Power supply voltage too low for LPG/CNG! – the controller power supply is too low to work
with LPG.
ƒ
Working time error – Controller Info has been damaged and automatically deleted. In this
case, the First PC Connection and First Settings Modifications info will not be shown.
The following warnings may appear in the Warnings window:
ƒ
LPG injectors fully open!!! – Check the lambda probe at full engine load – LPG injection loop,
i.e. an LPG injection’s started before the previous LPG injection ended. If the lambda probe
is “rich” at the time of this message, this warning may be ignored. Otherwise, replace the
injectors’ nozzles with higher diameter ones to decrease the multiplier.
ƒ
Inspection of Gas system required!!! The installation requires a periodical service visit. To
delete this message, go to the Controller Info settings, click “Set Inspection” and either set the
next service visit in kilometres or select “Off” in which case the service reminder will be
inactive.
There is a “Delete” button at the bottom of the screen used to delete all registered errors.