Autoenterprise WALL COMPLEX, Руководство пользователя

Страница: 16 / 25

USER MANUAL WALL COMPLEX
16
4.3 STATION CONNECTING
After transporting the charging complex, before installation, make sure that all internal
elements are properly fixed and there are no mechanical damages.
Check the quality of wire, loop, and connector connections. Check the tightening torque of
terminals, bolts, screws, and switchgear.
The charger does not require any special adjustment or tuning before it is put into operation.
Before you connect the charger, make sure that:
• The power supply cable on the mains side is de-energized by means of external
disconnecting devices.
• The mains supply is connected as shown in the wiring diagram: 3 phases with separate
Neutral (N) and grounding (PE) conductors
• When connecting with a 4-wire cable, carry out the protective grounding with a separate
wire.
To connect the complex to the electric circuit, it is necessary to open the cover of the charging
station and lead the power cable through the cable entry channel to the internal part of the
station.
ATTENTION! A combination lock is used. The default lock code is
“000”.
On the underside outer edge of the lock there is
hole for the code reset button. Rotate the face of
cam until the code reset button comes into view.
Push this pin in with a paper clip and keep it pushed
in.
Set your personal combination tuming the dials to
the desired combination.
Release the reset button and your combination is
set.
Next, you need to connect the power supply cable to the appropriate input busbars (as shown
in pic. 6). When connecting with a 4-wire cable, the external grounding should be done with a
wire of a cross section of at least 25 mm
2
by means of a bolted connection M10 with the
inscription «PE», located in the terminal compartment.