Autocom Air Helmet Fitting
To Fit Helmet Speakers and Microphone
1.
Mark in your helmet the position of your ear. This will allow you to take the full advantage of
the system’s sound quality*.
2.
Remove the protective paper from the back of the Velcro fixing pads and place them below
your markings in the helmet and apply pressure. Now place the speakers on the Velcro pads.
3.
Route the speaker cables to the Air unit cable and connect to the YELLOW plug marked “R”
and “L”.
4.
Remove the appropriate helmet padding and install the Autocom Boom Microphone, with the
microphone element centrally positioned, beige side close to the mouth.
5.
Route the Microphone cable and connect to the BLUE connector on the unit.**
*The closer the speakers are to the ears, the better the quality of the sound. The speakers can be placed under the
foam padding for better comfort. However, check this padding does not degrade the sound quality.
**For open helmets a kit is available to provide a cover for the microphone to help protect against wind noise.
To Fit Helmet Battery
1.
The battery should be fitted within the padding of the helmet in any convenient void.
2.
Route the battery cable and connect to the RED connector on the Air unit.
Содержание air
Страница 2: ......
