7
OPERATOR CONTROLS
CONTROL FUNCTIONS.
TOUCH SCREEN
The touch screen is the Human-Machine Interface used to select box style, input
dimensions, monitor progress, store and read back boxes, etc.
CREASE LEVER
The crease lever is used to set the depth of the creases along the box. When the lever
points down maximum creasing pressure is applied. Moving the lever upwards reduces
the creasing pressure for lighter creases or for heavier board.
It is recommended that a piece of scrap board be passed through the machine to test the
crease prior to making the first box.
GUIDE/BLADE ADJUSTMENT
A crank handle and a toggle switch are fitted to the side of the machine for adjusting the
board guides and blade. When a box program has been selected, the display will show a
blank size and two settings. The first setting relates to the smaller orange dial on the
end of the machine. It is the slot depth in millimetres and is set using the crank handle.
The second setting is the distance between the slots and this dimension is set on the
larger counter by pushing the switch up to increase, or down to decrease, until the
number shown is the same as that on the display.
Note:
The extreme right hand digit on both dials indicates 0.1mm i.e. to correctly enter a
setting of 100mm the dial should read 100.0
Switch to adjust
‘Setting 2’
Crease Lever
Touch Screen
Crank Handle to
adjust ‘Setting 1’
Conveyor On/Off
and speed adjust
EMERGENCY STOP
Primary 3-Phase
Isolator and
Start/Stop
Feeder Gate
Large Counter
Small Counter
Left-Hand Guide
