41
together we’re going places
...and sliding the clip
apart.
Rotate primary catch
down from its stored
position...
...rotate primary
catch anti-clockwise
to release the
tension on the clip
and un-latch it.
Push the roof upwards until the gas-struts elevate
the roof automatically to its full height.
Closing the elevating roof
Pull down the elevating roof using the two straps
attached to the handles on the roof panel. It is
advised that this process is stopped when the roof is
half closed to ensure the roof fabric is folding ‘inside’
the vehicle and will not get trapped between the
vehicle and the GRP roof moulding.
Special care
should be taken to ensure the fabric does not get
trapped between the latching mechanism as this
could cause damage to the material.
Note
: closing the roof is made much easier if a door
or window is left ajar whilst lowering as this lets the
increase in air pressure in the vehicle escape.
Securing the primary and secondary catches is just
a reversal of the un-latching procedure, but please
ensure no fabric is trapped in the mechanism as this
will damage the material.
Skylights
Your vehicle is fitted with skylights in the ceiling to
allow light and ventilation into the vehicle.
Opening the skylights
The clear transparent skylights are opened by
folding out the winding handle in the inner frame and
rotating anti clockwise to release the locking clamps.
Continue winding anti clockwise and the glazed
dome will hinge upwards to the desired amount.
Closing skylights
Rotate the winding handle clockwise until the glazed
dome is fully closed. Line up the handle with the
recess in the inner frame and fold the handle away.
Please ensure all skylights are fully closed and
locked before driving your vehicle away.
Omnivent
The omnivent can be opened for additional
ventilation by rotating the turn mechanism in a
clockwise direction; the glazed dome will hinge
open. Winding the mechanism anti clockwise will
close the glazed dome.
Blinds & Fly screens
The clear skylights are fitted with night blinds
and fly screens. The blinds and fly screens work
independently of each other by pulling them across
from the ends of the inner frame and clipping them
together. The desired night blind or fly screen can
then be fully drawn across the whole aperture.
Opening the blinds and fly screens is a reversal of
the above procedure.
Please note that all pleated night blinds should not
be left in the ‘fully closed’ position if the vehicle is
being left in storage for any period of time.
Skylights
Owners Handbook :
