16
1. Press and hold the
button for 3 second. The alarm will immediately sound.
2. During p anic mode, the normal function of this
transmitter button will be disabled. The transmitter
and
buttons can be used to lock and unlock the door (if the
option is installed), however once the
button is
pressed, the vehicle’s starter disable device, (where
installed) will be disengaged allowing the vehicle to start.
3. To stop the alarm, press and hold the transmitter
or
button on the
transmitter again for 3 seconds. Also, if any transmitter buttons other than
or
button is pressed and released, the panic mode will be turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30
seconds.
N. TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open /(if installed) Hood open / (if installed) Trunk open /
Turning on the ignition key will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking.
The siren, horn, parking lights, and dome light will turn on alerting of an intrusion for
30 seconds. Then it will stop and automatic reset and re-arm. If the any one of the
sensors or detectors is still active, the alarm system will sound a maximum of 3
times of 30 seconds cycles.
Trunk/Hood Trigger.
Door Trigger
Shock Sensor Trigger
Ignition Trigger
Warn-away Trigger
CLEAR THE FLASH ICON AND MELODY SOUND:
When the
alarm is triggered, the LCD screen will alert the user
through a melody sound and by flashing a trigger icon.
Press the
button 3 times within 3 seconds to clear
the flash icon and stop the melody sound on the LCD
screen transmitter.
STOP THE MELODY SOUND ONLY:
When the alarm is
triggered the LCD screen will alert the user through a
melody sound and a flashing trigger icon. Press any
button on the LCD remote transmitter to stop the melody
sound.
NOISE ABATEMENT CIRCUIT:
Your system has a “Noise Abatement Circuit”. It
prevents annoying repetitive trigger sequences due to faulty door pin switches or
environmental conditions such as thunder, jackhammers airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers five times. Each
time, the same sensor or switch has triggered the alarm; the “Noise Abatement
Circuit” will interpret this pattern of triggers as a false alarm. After the third trigger,
the “Noise Abatement Circuit” ignores, or bypasses, that sensor or switch until a
different sensor or switch is trigger.
