Installing the Holster
NOTE:
Place the holster on a location where no tension is applied to the charging cable.
1. Place the wall dock on the wall and level it using a spirit level.
2. Mark the three mounting holes (I) with a pencil and drill
three 5/16" holes.
3. Insert three 5/16" diameter wall plugs (J) into the holes.
4. Attach the wall dock to the mounting location by screwing
three M6 x 50 screws (K) into the holes. Tighten the screws
using the screwdriver type PH2.
1. Align the three connecting points (M) of the holster with the
installation slots (L). Make sure they are connected securely.
2. Screw the M5 x 12 screw (N) into the hole at the bottom of
the holster and tighten the screw to secure the holster using the
screwdriver type T25.
J
K
I
Wall
L
M
N
Wall
Drape the charging cable over the top of the charger
or holster and dock your EV connector in it.
11
1
2
3
