Autel Robotics EVO II RTK V3 Series, Руководство пользователя

Страница: 54 / 65

54
the camera.

After the upgrade, the remote controller may be disconnected from the aircraft.
To pair them again, refer to Section 2.2.2.
5.2 Troubleshooting
Question 1: An error is found when the aircraft performs the self-check (the LED
indicator at the tail of the aircraft glows solid red).

This is a hardware issue. Please contact Autel Robotics' customer support:
www.autelrobotics.com/page/contact .
Question 2: If the motor cannot start, check the following:

Check whether the remote controller is paired with the aircraft.

Check whether the remote controller is correctly calibrated.

Check whether the aircraft is fully charged.

Check whether the compass is correctly calibrated.

Check whether the GPS is available (when you enable the beginner mode).
Question 3: If the aircraft cannot take off after you start the motor, check the
following:

Check whether the aircraft is in a No Fly Zone.

Check whether the aircraft is placed on a flat surface.
Question 4: Why is the flight time shortened?

The common causes are low temperature and wind speed.
Question 5: There is no response from the remote controller when pairing it with the
aircraft.

Check whether there is a metal object, mobile device or other remote controller
near.
Question 6: The video link fault occurs or is interrupted often.

Check whether there is any magnetic or signal interference source near the
aircraft and remote controller.
Question 7: The camera automatically turns off during recording.

Do not pull out the micro SD card from the camera. Restart the camera and wait
for the video file to be stored as much as possible.
Question 8: The video link is interrupted when the aircraft is not out of your sight.

Enable auto-return and let the aircraft return to the home point.