AUTEC Air LK6, Оригинальное руководство пользователя

Страница: 12 / 16

12
LILK6E00-01
Operation
AUTEC - Air series
7.3.5 BACK-UP UniT
If the main transmitting unit cannot be used because it has been lost or damaged, it can be
replaced with a transmitting unit called "BACK-UP UNIT".
It is identical to the unit that cannot be used anymore; the only difference is the presence of
the plate “BACK-UP UNIT” on the battery housing.
set diP switch 2 in the "BACK-UP UniT" as shown in the technical data sheet.
if the transmitting unit that can no more be used requires either a "Key id
0-1" or an "id internal tx memory" (see technical data sheet), move it to the
"BACK-UP UniT" and perform the address saving procedure described below.
if the transmitting unit that can no more be used does not require either a
"Key id 0-1" or an "id internal tx memory" (see technical data sheet), perform
the PAir procedure to pair the “BACK-UP UniT” with a receiving unit (the
technical data sheet shows which PAir procedure to use).
Address storage
With fully charged battery and power keyswitch in the "BACK-UP UNIT", perform this procedure:
1. press the START pushbutton until the green and red LEDs light up.
2. wait until the green LED blinks slowly
3. within 3 seconds, activate in sequence the commands corresponding to PIN 1, PIN 2 and
PIN 3 that compose the PIN code given in the technical data sheet.
If the PIN code is incorrect, the red LED illuminates and the transmitting unit switches off. In
this case, the storage procedure shall be repeated.
If the PIN code is correct, the green LED turns steady on and the transmitting units switches
off: this indicates that the address has been stored in the "BACK-UP UNIT". It is now
possible to start the radio remote control and control the machine with the "BACK-UP UNIT"
transmitting unit.