TROUBLESHOOT
Question 1:
The magnetic resistance brake cable does not reach the housing clip.
Answer:
Make sure to adjust the lever on right arm to low resistance so that the magnetic resistance
brake cable can reach the housing clip.
Question 2:
The bolts on the center column are having difficulty going in.
Answer:
If possible, recruit a mate to hold the center column in position while you connect the computer
cable and fasten the bolts. If the center column receiving insert is not lined up when you try to
fasten the bolt you could run into a position of cross threading and therefore making it more
difficult to tighten. Don’t forget to leave the two arms a little bit loose before attaching the
center column as this will give you a little bit of tolerance to pivot them into alignment.
See Fig 1. below, Once everything is in the correct position, give all bolts a final tighten
FIGURE 1
