3.
MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu Brumbys
to Cab Chassis aluminium trays.
2.1 BASIC TOOL REQUIRED
-
Drill, 4mm drill bit
3.2
MULTI-FIT SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
- 2 x grub screws
-
2 x solid bar end piece
2.3 FITTING MULTI-FIT BAR
1.
Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders
with the holes facing to the ground (so the grub screws don’t rub against the tonneau), as shown above
and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.
This is where you will drill a hole to the depth of about 1-2mm (do not go any further)
2.
Join the pieces back together and screw grub screws through the hollow bar into the holes that you
drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may kink the bar in the
middle to give it some extra height to assist with water runoff.
4.
WARRANTY AND FEEDBACK
Register now to activate your 3 year warranty by filling out our online form!
QR Code:
Website Link
:
http://www.aussietonneaus.com.au/en-au/warranty-card-request-form.html
Please complete our 2 minute feedback section as we strive to constantly improve for
our customers
.
Thank you for purchasing an Aussie Tonneaus Product.
