Aussie Eco-Clean Super Indy Operating & Maintenance Manual -
2020
CLASSIFICATION
The user must observe the conditions of use of the applian-
ce prescribed by the Rules, and particularly he must respect
the following classification:
As for the protection against electric shock, the H.P.cleaner
belongs to CLASS I.
The H.P. cleaner is factory set and all its safety devices are
sealed.
It is forbidden to alter their adjustment values.
The water in this machine is heated by a diesel fueled burner.
The H.P. cleaner must be always used on a firm and flat
ground, furthermore it must not be moved while it is working or
connected to the electric supply.
Failure to observe this prescription may cause danger for the
user.
The H.P. cleaner must not be used in the presence of corrosive
or potentially explosive atmospheres. (vapours or gas).
The electrical installation must be performed by qualified tech
-
nicians who are able to work in observance of the governing
rules (in compliance with the provisions of the IEC 60364-1
standard) and of the manufacturer’s instructions.
Any damage to persons or property as a result of incorrect
electrical installation is not the responsiblity of the manufac-
turer.
Machines under 3kW are fitted with a plug. Check the data plate
on the machine and ensure that the power source is suitably
rated and earthed. If an alternative plug needs to be fitted use
a qualified electrician.
Do not use extensions to feed the H.P. cleaner.
The electric safety of this machine may be assured only when it
is properly connected to an efficient grounding system in accor
-
dance with the governing laws for electric safety. (in compliance
with the provisions of the IEC 60364-1 standard).
It is necessary to check this essential safety requisite. In case
of doubt, ask for accurate control of the power system by
qualified personnel.
The manufacturer may not be considered responsible for dama-
ges occurred because of the lack of the grounding system.
The H.P. cleaner must be connected to the electric supply by
means of an omnipolar switch with opening contacts of at least
3 mm. This switch must have electric features which are consi-
stent with the appliance. (This requisite does not apply to H.P.
cleaners with plug and electric power lower than 3 kW).
The appliance is disconnected from the electric supply only by
pulling out the plug or switching off the omnipolar switch.
Failure to respect the above absolves the manufacturer of all
liability and represents negligent use of the product.
The water cleaner is considered as a fixed device.
Water cleaners with the “Total Stop” device should be con-
sidered as off when the omnipolar switch is in the “O” position
or the plug is unplugged from the socket.
The most important instructions
are marked with the symbol:
INTRODUCTION
This manual must be read before installing, setting up and
using the cleaner. The manual is an integral part of the product.
It is composed of two parts, one of which is yellow.
Read the warnings and instructions in this manual carefully as
they provide important indications as to
SAFETY IN USE and
MAINTENANCE
, paying special attention to the general rules
for safety listed in the yellow booklet.
KEEP THIS MANUAL CAREFULLY FOR FUTURE CON-
SULTATION.
The contents of this booklet must be brought to the attention
of persons using or carrying out routine maintenance on this
water cleaner.
!
!
!
!
|
7
