- 4 -
4. Master-Slave Operation (Auto, Sound Active Mode)
Master/Slave setting
To set Master unit, press FUNC button
↑↓
and select F6 and then press VALU button
⊕ to
set its value to Y.
Press SAVE button to save the setting. LED display would show PASS to
confirm the setting is saved well.
To set Slave units,
press FUNC button
↑↓
and select F6 and then press VALU button
⊖ to
set its value to N
. Press SAVE button to save the setting. LED display would show PASS to
confirm the setting is saved well.
Auto/ Sound Active setting
Repeat above setting procedures of Auto/ Sound Active mode introduced in Stand-Alone
operation introduction.
5. DMX Operation
To run this unit in DMX mode, connect the unit to any standard DMX controller via XLR connectors.
Please consult DMX controller manual to determine address.
DMX mode setting
Set VALUE of F4, F5 and F6 to N. Remember to save the settings by pressing SAVE button for
each change.
DMX address setting
Press
FUNC
button
↑↓
and select A***.
Input DMX address by pressing VALU button
⊖⊕
.
Press SAVE button to save the setting. LED display would show PASS to confirm the setting
is saved well.
