VIII.
Mounting & Installation
The WMB-700 back box is sold separately from the NXT-700. The back box is designed to be mounted
into most drywall style installations of various thickness as well as podium wood panels.
The WMB-700 does have a top/bottom orientation which is shown in figure 1. If not mounted correctly
the panel will be upside down. An opening of approximately 7.72” (196mm) L x 5.75” (146mm) H will
allow the back box to snuggly fit into the wall. Once pushed into the opening, use the 4 supplied L
brackets to secure. This can be done from the inside of the box by holding the screw and inserting the L
into the T intersection towards the back of the WMB-700 until the entire L is on the outside of the unit
with the screw and washer on the inside of the unit. Note the notch at the end of the L bracket as it is used
to guide the bracket up and down and keeps it from spinning when tightening. Slide the L bracket
towards the front and tighten once snug. Do opposite corners first to make it easier the finish with the
remaining 2.
Figure 1
