AURATON RTH, Руководство пользователя, Страница: 7 / 16

Signing out device from RTH receiver
1 . Signing out the device from the RTH
receiver is initiated by pressing the right
sign out button (red triangle
- ) on the
receiver and pressing it for at least 2 sec,
until the LED diode starts flashing with a red
light, then we release the button.
Note : The receiver is waiting for signing out
of the device for 120 seconds. After this time
it will automatically return to normal
operation.
7
OFF
ON
IN
OUT
LED
2 . When the LED diode of the receiver flashes with a green light, press the
"association button" on the device that you want to sign out and hold it
pressed for at least 2 seconds (precise signing out manual is attached to
each device).
.
3 . Correct completion of signing out is signalled by the stop of flashing with a
red light of the LED diode on the receiver and the receiver going into normal
operation.
In the case of an error, steps 1 and 2 should be repeated.
RESETTING - Signing out all devices
assigned to receiver
In order to sign out all devices associated with the
receiver press and hold at the same time both
association and sign out (
and ) buttons for at
least 5 seconds until signalling of the LED diode
changes to alternate flashing in colours green and
red. Then release both buttons.
Correct completion of signing out of all devices is
signalled after approximately 2 seconds by
signalling change to green and then its fading
.
AURATON RTH
OFF
ON
IN
OUT
ALARM
RESET
Note : If after RESETTING we disconnect the receiver from the power supply
and then we connect the power supply again, the receiver will
automatically go into the "association" mode, just as at the first start-up.