
Upon fulfillment of the above requirements, the RTH receiver goes into
automatic mode of controlling the air-conditioning. If we connect,
through the transmitter, the power supply circuit for air-conditioning
devices and open or slightly open any window with an associated H-1
handle or window position sensor for longer than 30 sec, the transmitter
will turn off the air-conditioning device.
If all windows with an associated H-1 handle or window position sensor
once again will be in a position other than open or ajar, the RTH receiver
after time not shorter than 90 seconds from deactivating the transmitter
once again will activate the transmitter and the air-conditioning device.
This is an intentional delay so as to prevent too rapid changes of air
conditioning devices between ON-OFF position, which can lead to
compressor damage
.
B
)
L
oss of signal
.
When the RTH receiver loses signal from the associated H-1 handle or
window position sensor (3 subsequent lost transmissions), it changes
the status of this window to closed. After restoring the transmission once
again the sensor is correctly read by the receiver
.
Note
:
associating the T-1 controller or the T-2 thermometer automatically
changes the way of operating of the RTH receiver to controlling the heating
device
.
12
Signalling operation and receiving
data package
Each reception of the radio transmission by the AURATON RTH receiver
from associated devices is signalled by a temporary change of the LED
diode colour to orange. After activating the transmitter the LED diode is
red, after shutting down the transmitter the LED diode is green.
Содержание RTH
Страница 1: ...User s Manual RTH www auraton pl OFF ON IN OUT ALARM RESET ...
Страница 16: ...www auraton pl ...