Rev. A 05/26
AM11MF30-1
4
4. Connect the two wires, and close the electrical
housing with housing lid in
bag 2
(B-2 and B3).
B-2
B-3
5. Align and slide Base Cover onto Fan Pole Assembly.
Fasten to back and front of mist control / fan pole
assembly with two screws from
bag 3
(C-1).
C-1
6. Install mist control unit by using fasteners from
bag 4
7.
Pull the water and air tube through the opening on
the side of the fan pole assembly until they are
inserted securely in the “Push-In” connector (C-2).
C-2
ATTENTION
: To use a “One-Touch or Push-to-Connect
fittings simply slide the hose into the fitting full, you
should feel two clicks (C-3). Failure to do so could
result in a leaky connection. To remove the hose, slide
the hose out of the fitting while pushing the plastic ring
on the fitting in (C-4).
FAN POLE ASSEMBLY TO MOTOR
ASSEMBLY
1. Attach motor to the Center Pole and fasten securely.
(D-1) Remove the two screws pre-installed on the top
of the Fan Pole, align the Fan Motor on the pole with
the mounting holes and re-insert the screws
securely.
D-1
FAN GUARD AND BLADE ASSEMBLY
1. Remove the four screws pre-installed on the fan
motor (E-1). Locate the small screw and nut at the
bottom of the rear guard and position it so it is
pointing to the ground. Mount the rear guard to the
fan motor with screw (E-1).
Base cover
Electrical Housing Lid
C-3
C-4
Mist control unit
Air hose
Water hose
