GB 7
GB 6
5. Attach the back motor (151747)
to the underside of the base frame
using the screws and locking pin
as shown in the illustrations (see
fig. 7).
6. Attach the upper leg motor
(151748) to the underside of the
base frame using the screws and
locking pin as shown in the
illustrations (see fig. 7).
7. Insert the plug of the back motor
into connection point 1 on the
control box.
8. Place the included battery in the
infrared handset and insert the
plug of the receiver in connection
point 2 on the control box.
9. Insert the plug of the upper leg
motor into connection point 3 on
the control box.
10. Secure the cables by fastening the
cable clamp on the control box.
(see fig. 8).
11. Slide the control box onto the
clamp at the underside of the
frame (see fig. 9).
12. For synchronous adjustment,
attach the synchronic cable to
control boxes (both ends of the
cable are identical) and to the
infrared receiver.
13. Using the adhesive strip, attach
the infrared receiver to the outside
of the bed against the base frame.
Make sure that the receiver is not
obstructed.
3. Assembly
3.1 The components of your Kiruna
- Kiruna Boxspring
- 2 Electric motors with handset and
control box*
- Mattress*
- Top mattress
- Legs
3.2 Assembly of upper frame and base
frame and installing the electric
m o t o r s
1. Remove the upper frame from the
packaging and lay it upside down
on the floor.
2. Remove the base frame from the
packaging and place it on the
upper frame.
3. Attach the frames using the bolts
and washers (see fig. 5).
>> In case of assembly of the flat
Kiruna, go to chapter 3.3.
>> In case of assembly of the
adjustable Kiruna, go to point 4.
4. Attach the lifting arms on both
sides of the foot end (see fig. 6).
*If applicable
fig. 5
fig. 7
(foot)
fig. 8
fig. 9
fig. 6
